Figure 208. USB hypervisor flash device removal
Step 5.
If you are instructed to return the flash device, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing a USB embedded hypervisor flash device
Use this information to replace a USB embedded hypervisor flash device.
To install a USB hypervisor flash device, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 297.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the top cover (see "Removing the top cover" on page 149).
Step 4.
Remove the riser-card assembly (see "Removing a riser-card assembly" on page 186).
Step 5.
Align the flash device with the connector on the system board and push it into the USB connector
until it is firmly seated.
254
Lenovo System x3650 M5 Installation and Service Guide
USB embedded
hypervisor
flash device