Zeiss humphrey HFA II-i series Field Service Manual page 345

Instrument: General
Subject: Test Equipment Calibration & Certification
Status: Informational
This bulletin replaces Service Bulletin GEN-002F & GEN-007C.
Domestic Field Service
Calibration controlled test equipment, issued to the Domestic Field Support Engineer, is managed as an
exchange pool by the Carl Zeiss Meditec Calibration Lab located in Dublin, California. The Calibration
Coordinator will send notification as to when specific test equipment is due for recalibration.
International Field Service
1) Calibration Controlled Test Equipment
Refer to "Table 1" for required action based on test equipment type.
2) Periodic Certification and Charges
Equipment calibration is required
designated.
Note - It is the User's responsibility to ensure that periodic calibration certification is performed before
the specified expiration date. A calibration sticker, attached to the test equipment, indicates the date of
certification and its expiration date.
Shipping charges are not included in the calibration prices. User is responsible for shipping charges to
and from Carl Zeiss Meditec.
Additional charges for parts and labor will apply if the equipment is damaged or requires major repair
before calibration can be performed. If the test equipment is not repairable, you will be notified and the
defective test equipment will be returned to you. You will then need to order new test equipment.
3) Equipment Calibration Certification
The calibration of test equipment does not include the cost for a calibration certification certificate.
Certification of test equipment requires an additional cost per kit or item (including any sensors, loads,
or elements). A calibration certificate may be requested for an additional $75.00 per certificate.
This bulletin has been completely revised.
Annually (Yearly)
iii PROPRIETARY and CONFIDENTIAL iii
SERVICE
for all of the items listed in Table 1, except where
BULLETIN
No.: GEN-002G
Date: 28 Apr 08
Pages: 2