Omron CJ1W-DRM21 Operation Manual page 179

User-set Remote I/O Allocations Using the CX-Integrator
1) Enable slave communications in CJ1W-DRM21 Properties using the CX-Integrator.
2) Create the device parameters to set slave communications.
3) Save the data as a device parameter file.
4) Read the device parameter file, go online,
and download the file to the DeviceNet Unit
slave.
Note Enable slave communications in CJ1W-DRM21 Properties if the CX-Integrator is used.
CJ-series DeviceNet Units Operation Manual for NJ-series CPU Unit(W497)
Connect the CX-Integrator to the NJ-series CPU Unit.
Switch the CPU Unit to PROGRAM mode.
Define user-defined variables in the area to which I/O data is allocated.
Switch the CPU Unit to RUN mode.
Slave remote I/O communications will begin.
5 Remote I/O Slave Communications
3) Go online and directly download the device
parameter file to the DeviceNet Unit slave
without saving the file.
5
5-5