Omron CJ1W-DRM21 Operation Manual page 163

Allocation Procedures
Step 1
Set the area, start word, and words allocated for each block with the use of the CX-Integrator.
Step 2
Allocate words to all node addresses in each block as shown below with the use of the CX-Integra-
tor.
OUT block 1
Node address 00
Node address 03
IN block 1
Node ad- Node ad-
dress 02
dress 01
• Each address is allocated at least one byte (rightmost or leftmost byte).
Note a) You can set the order of all blocks as you desire.
b) Node addresses do not have to correspond between an output block and input block.
Example:
c) The same node address cannot be allocated more than once.
Example:
CJ-series DeviceNet Units Operation Manual for NJ-series CPU Unit(W497)
Node address 00: DRT1-OD16 (16 output pts)
Node address 03: DRT2-DA02 (2 analog output points = 32 bits)
Node address 01: DRT1-ID08 (8 input pts)
Node address 02: DRT1-ID08 (8 input pts)
OUT block 1
IN block 2
OUT block 2
IN block 1
This is not necessary.
OUT block 1
Node address 01
Node address 02
Node address 03
OUT block 1
Node address 02
4 Remote I/O Master Communications
IN block 1
Node address 01
Node address 02
OUT block 2
Node address 02
4
4-23