Table of Contents
Advertisement
ADASH Ltd.
Before Switching On
Ignoring any recommendations mentioned below may cause failure of the device.
Operating with a power higher then 24 V can cause an accident.
General warnings
Never connect higher then 30 V to the Analyzer !
Only suitable ICP powered sensors can be connected to the AC signal inputs.
If the measurement without ICP power is required, ICP power must be switched off. You can damage the
external signal source, which is not protected against ICP powering.
AC channels - voltage higher then
DC channels - voltage higher then
Always use only original cables designed for connection with sensor.
Long push and hold of POWER button evokes incorrect instrument switching off. Data could be lost.
If you are unsure, contact your distributor or the manufacturer.
PC USB connection warning
Switch off the A4400 instrument when you connect/disconnect it to/from computer by USB cable.
For further technical and contact information visit www.adash.eu, email: info@adash.cz
±
18 V (peak) can damage the instrument.
±
30 V (peak) can damage the instrument.
8
Adash 4400 – VA4Pro
Advertisement
Table of Contents
