Before Switching On The Analyser; Indication Of Weak Batteries (Re-Chargeable) - Adash 4300 - VA3 User Manual

Adash Ltd.

Before Switching On the Analyser

Ignoring any recommendations mentioned below may cause failure of the instrument.
Operating with a power higher then 24 V can cause an accident.
1. Connect into the ICP input only:
ICP powered sensor
-
AC voltage max. 12 V peak-peak
-
- DC voltage max. +/- 24 V.
If you are not sure, contact your dealer or directly our website.
2. Never connect the analyser to a line voltage 230 V (110 V).
3. Only use batteries with a nominal voltage of max. 1.5 V.
Be careful of battery orientation!

Indication of Weak Batteries (re-chargeable)

When you select the Instrument info from main menu, then information on the current condition of
the batteries appears.
While the instrument is switched on, the battery condition is checked every 30 sec.
1. When a warning low battery level is detected (insufficient to enable correct and safe work with
instrument), the yellow ERR light is on (on the top of keyboard). Finish your current
measurement and then change the batteries.
2. When the alert low battery level is detected, all three lights on the top of the keyboard blink
three times and instrument switches itself off. You have to change the batteries immediately. If
the instrument switches itself off after switch-on, then you also have to change the batteries
immediately.
When the instrument is switched off for several
minutes, weak batteries can be regenerated and for
a limited time can seem to be in good condition.
Do not try repeatedly switching on, when the
instrument itself switches off immediately! You may
cause instrument failure and data in memory can be
Adash Ltd., Czech Republic, Tel.: +420 59 6232670, Fax: +420 59 6232671, e-mail: info@adash.cz
For further technical and contact information consult www.adash.net, www.adash.cz
Warning!
Attention!
corrupted.
3
A4300 - VA3 - Balancing