The Fasit; Set-Up; Sensor Settings; Units - Adash 4400 VA4 Pro User Manual

ADASH Ltd.

The FASIT

The FASIT means the FAult Source Identification Tool. This mode should help beginners to determine the
machine condition.
Attention !
The FASIT correctly analyses only machines with speed over 10Hz (600 RPM). The velocity measurements is
in the 10-1000Hz range.

Set-up

Select the FASIT mode. The menu appears.
Channel:
The number of the input channel
The menu can be repeatedly opened by pressing FASIT Settings button.

Sensor Settings

In the Sensors item set up the parameters of the chosen sensor. FASIT uses the measurement of acceleration
or velocity from one channel. If you will use a velocity sensor, the bearing condition is not detected. For bearing
condition detection the acceleration measurement is necessary.

Units

The displayed units can be set up under the Global/Global Settings. Set up the unit of speed (Hz, RPM, CPS,
CPM) in the Speed Unit item. The vibration values are displayed according to the setting of Units (metric,
imperial).
The units are set up as follows:
metric:
acceleration - g
velocity - mm/s
imperial:
acceleration - g,
velocity – in/s

Measurement

Press the Start button to start the measurement. The speed needs to be known for the processing of this
measurement. The speed detection is described in the Speed Detection chapter.
For further technical and contact information visit www.adash.eu, email: info@adash.cz
94
Adash 4400 – VA4Pro