The Procedure - Adash 4400 VA4 Pro User Manual

ADASH Ltd. Adash 4400 – VA4Pro
Sensor mounted near to lubrication point
If vibration diagnostic measurements are performed on a machine, then a measurement pad is already
mounted. This pad can be used also for lubrication measurements.

The procedure

1. Mount the sensor near to the bearing. Prepare the greasing gun for use.
2. Select the Lubri Mode and the input channel, which will be used for measurement. Push the START button.
Then the instrument will automatically measure an actual lubrication state.
In the beginning the instrument takes the initial g RMS value in the frequency band 500 - 25600 Hz.
101
For further technical and contact information visit www.adash.eu, email: info@adash.cz