Table of Contents
Advertisement
ADASH Ltd.
Automatic change of view
When the measurement is ran, the machine view replaced by measurement view.
Buttons in Machine View
Fit
Auto-zoom of machine in window.
Arrow Mode
Changes the arrows functions.
Point
Moves the point selection (blinking circle). When the new selection is confirmed by OK, then the selected
direction is also moved to that point.
Direction
Moves the direction selection (on selected point). The new direction for measurement can be manually entered
by Enter Direction button.
Zoom/Move/Rotation
Zoom/Move/Rotation of machine.
Blink on/Blink off
The directions which are not measured yet can be blinking.
Hide on/Hide off
The directions which are measured yet can be hide.
Start/Stop Animation
Run or stop animation.
Enter Direction
Manual entry for direction number.
Start
Starts new measurement.
Buttons in Measurement View
The most of buttons have the same function as in Analyzer mode.
180° on/180°off
Sometimes it is possible to mount the sensor to direction which is defined in geometry. Usually in such case is
possible to mount the sensor in opposite direction. The use this button and change the phase of 180 degrees.
For further technical and contact information visit www.adash.eu, email: info@adash.cz
113
Adash 4400 – VA4Pro
Advertisement
Table of Contents
