Table of Contents
Advertisement
Figure 52. Software RAID signal cable routing for redundant power supply
Step 4.
Lift the backplate out of the server.
Step 5.
Slide the replacement backplate into the guide channels, making sure that any nearby wires or
cables are not trapped or pinched.
Step 6.
Press on the two blue touch points firmly until the replacement backplate is fully seated.
Step 7.
Connect the respective signal and power cables of the replacement backplate to the hardware
RAID card and power supply (fixed or redundant).
Note: Make sure the relevant cables pass through the cable clips.
.
Chapter 6
Removing and replacing components
175
Advertisement
Table of Contents
Troubleshooting
