Lenovo System x3250 M4 Installation And Service Manual page 160

• Before you remove any component of a RAID array, back up all RAID configuration information.
To remove a simple-swap hard disk drive from the bay, complete the following steps:
Read the safety information in "Safety" on page v and "Installation guidelines" on page 33.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
Step 1. Make sure that the server top cover is in place and fully closed
Step 2. Remove the filler panel from the bay.
Step 3. Remove the hard disk drive:
• To remove a 3.5-inch simple-swap hard disk drive, pull the loops of the drive tray toward each
other and pull the drive out of the bay.
Hard disk
drive assembly
• To remove a 2.5-inch simple-swap hard disk drive, press the release latch and pull the drive
out of the bay.
Hard disk
drive assembly
If you are instructed to return the server component or optional device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
146
Lenovo System x3250 M4 Installation and Service Guide
SATA hard disk
drive back plate
Filler panel
SATA hard disk
drive back plate
Filler panel