Table of Contents
Advertisement
To remove the DVD drive, complete the following steps.
Step 1.
Remove the cover (see "Removing the cover" on page 131).
Step 2.
Press the release tab (the rear of the drive-retention clip) toward the drive right side of the server to
release the clip; then, while you press the tab, push the drive out of the bay.
Note: You might have to push the right-rear corner of the drive toward the front of the server
to move the drive initially.
Step 3.
Remove the retention clip from the drive.
Drive retention clip
Alignment pins
Step 4.
If you are not replacing the DVD drive, reinstall the DVD drive filler.
a.
Attach the drive-retention clip to the side of the DVD drive filler that you removed.
b.
Slide the DVD drive filler into the DVD drive bay until the drive filler clicks into place.
Release tab
.
Chapter 6
Removing and replacing components
151
Advertisement
Table of Contents
Troubleshooting
