Table of Contents
Advertisement
Hard disk
drive assembly
Figure 13. 3.5-inch simple-swap hard disk drive installation
b.
Gently push the drive into the bay until the drive stops.
Step 4.
Reinstall the drive bay filler panel that you removed earlier.
Step 5.
If you are installing additional simple-swap hard disk drives, do so now.
If you have other devices to install, do so now. Otherwise, go to "Completing the installation" on page 54.
Installing the optional DVD drive
Use this information to install the DVD drive.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 33.
If you are installing an optional device in the server, turn off the server and peripheral devices, and disconnect
the power cords and all external cables.
To install the DVD drive, complete the following steps.
Step 1.
Remove the DVD drive filler panel if it is installed. Locate the blue release tab on the rear of the DVD
drive filler panel; then, while you press the tab, push the DVD drive filler panel out of the drive bay.
42
Lenovo System x3250 M4 Installation and Service Guide
SATA hard disk
drive back plate
Filler panel
Advertisement
Table of Contents
Troubleshooting
