Table of Contents
Advertisement
Read the safety information in "Safety" on page v and "Installation guidelines" on page 33.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To replace the power paddle card, complete the following steps.
Step 1.
Align the power paddle card with the standoffs on the system board and lower the power paddle
card onto the system board until it is secure.
Step 2.
Reinstall the safety cover (see "Replacing the 240 VA safety cover" on page 187).
Step 3.
Reconnect the power cable to the DVD power cable (if available).
Step 4.
Reconnect the cables to the hard disk drive backplane or the backplate assembly.
Step 5.
Reconnect the power cables to power connectors on the system board.
Power paddle card
.
Chapter 6
Removing and replacing components
191
Advertisement
Table of Contents
Troubleshooting
