Danfoss VLT AQUA Drive Operating Instructions Manual page 71

®
VLT AQUA Drive
Operating Instructions
0-70 Set Date and Time
Range:
2000-01-01 00:00 – 2099-12-01
*
23:59 [2000-01-01 00:00]
0-71 Date Format
Option:
* YYYY-MM-DD
[0]
[1] DD-MM-YYYY
[2] MM/DD/YYYY
0-72 Time Format
Option:
* 24 H
[0]
[1] 12 H
0-74 DST/Summertime
Option:
*
OFF
[0]
[2] Manual
0-76 DST/Summertime Start
Range:
*
2000-01-01 00:00 [2000-01-01
00:00 – 2099-12-31 23:59 ]
0-77 DST/Summertime End
Range:
*
2000-01-01 00:00 [2000-01-01
00:00 – 2099-12-31 23:59 ]
8.2.3. General Settings, 1-0*
Define whether the frequency converter operates in open loop or closed loop.
1-00 Configuration Mode
Option:
* Open loop
[0]
Display Line XXX
or par. 0-24, . Use the
buttons to move the cursor. When a character is highlighted by the cursor, this character can be changed. A
character can be inserted by placing the cursor between two characters and pressing
Function:
Sets the date and time of the internal clock. The format to be used is set in par. 0-71 and 0-72.
NB!
This parameter does not display the actual time. This can be read in par. 0-89. The clock will
not begin counting until a setting different from default has been made.
Function:
Sets the date format to be used in the LCP.
Sets the date format to be used in the LCP.
Sets the date format to be used in the LCP.
Function:
Sets the time format to be used in the LCP.
Function:
Choose how Daylight Saving Time/Summertime should be handled. For manual DST/Summertime enter the start
date and end date in par. 0-76 and par. 0-77.
Function:
Sets the date and time when summertime/DST starts. The date is programmed in the format selected in par.
0-71.
Function:
Sets the date and time when summertime/DST ends. The date is programmed in the format selected in par.
0-71.
Function:
Motor speed is determined by applying a speed reference or by setting desired speed when in Hand Mode.
Open Loop is also used if the frequency converter is part of a closed loop control system based on an external
PID controller providing a speed reference signal as output.
®
MG.20.M4.02 - VLT is a registered Danfoss trademark
8. How to programme the frequency converter
▲ ▼
or buttons on the LCP to change a character. Use the
◀ ▶
and
▲ ▼
or .
8
71