Table of Contents
Advertisement
Chapter 13
SNMP Commands
This chapter describes the commands that you use to configure SNMP on the W310:
•
clear snmp trap
•
set snmp community
•
set snmp retries
•
set snmp timeout
•
set snmp trap
•
set snmp trap auth
•
show snmp
•
show snmp retries
•
show snmp timeout
clear snmp trap
User level: privileged, supervisor.
Use the clear snmp trap command to clear an entry from the Simple Network
Management Protocol (SNMP) trap receiver table.
Syntax:
The syntax for this command is:
clear snmp trap {<rcvr_addr> | all}
Syntax
<rcvr_addr>
all
Example:
W310-1# clear snmp trap 192.168.173.42
SNMP trap deleted.
Avaya W310 Command Reference Guide
Description
IP address or IP alias of the trap receiver (the SNMP
management station) to clear
Keyword that specifies every entry in the SNMP trap receiver
table
325
Advertisement
Table of Contents
