Lb-Mode - Avaya W310 Command Reference Manual

Chapter 8 LAP and Radio Card Commands
Example:
To set the maximum allowed difference for transmission processing time between adjacent
APs to a value other than the default:
W310-1(super/LAP lobby/802.11a first-slot)# lb-adj-ap-
time-difference 200
This command will reboot the LAP(s) - do you want to
continue (Y/N)? y
To return to the default value of 100 milliseconds:
W310-1(super/LAP lobby/802.11a first-slot)# no lb-adj-ap-
time-difference
This command will reboot the LAP(s) - do you want to
continue (Y/N)? y

lb-mode

User level: privileged, supervisor.
Command Mode: Radio card, Template
Use the lb-mode command to enable or disable load balancing. Load balancing is used in
radio wireless LANs to prevent any one Access Point from becoming responsible for too
much network traffic. When multiple Access Points are installed and several nodes are
competing to send data to them, load balancing ensures that all of the Access Points work
together to move the data across the wireless LAN. The default value is disabled.
Use the [no] form of this command to return to its default value of enabled.
Syntax:
The syntax for this command is:
lb-mode <active | not-active>
Syntax
<active>
<not-active>
108
Description
Enables load balancing for the Access Point interface.
Disables load balancing for the Access Point interface.
Avaya W310 Command Reference Guide