Table of Contents
Advertisement
Chapter 8
LAP and Radio Card Commands
max-rx-lifetime
User level: privileged, supervisor.
Command Mode: Radio card, Template
Use the max-rx-lifetime command to specify the elapsed time in time units (TU) after
the initial receipt of a fragmented MAC Management Protocol Data Unit (MMPDU) or
MAC Service Data Unit (MSDU) that will terminate any further attempt to reassemble the
MMPDU or MSDU.
Use the [no] form of this command to reset the elapsed time to its default.
Syntax:
The syntax for this command is:
[no] max-rx-lifetime
Syntax
<time>
Message:
After this command is initiated, the LAP must reboot for any change to this setting to take
effect. The following message displays after you initiate this command:
This command will reboot the LAP(s). Do you want to continue (Y/N)?
•
Type Y to reboot the LAP.
•
Type N to cancel the reboot. The change in this setting will not take effect.
Example:
To set the maximum elapsed time:
CW310-1(super/LAP lobby/802.11a first-slot)# max-rx-
lifetime 200
The command will reboot the LAP(s) - do you want to
continue (Y/N)?
Done!
112
<time>
Description
Elapsed time in time units. The default is 256. The range for this
value is 1 through 4294967295.
Avaya W310 Command Reference Guide
Advertisement
Table of Contents
