Chapter 13
SNMP Commands
Example:
To add an entry in the SNMP trap receiver table with default:
W310-1# set snmp trap 192.168.173.42
SNMP trap receiver added.
Related Commands:
•
Use the
•
Use the
set snmp trap auth
User level: privileged, supervisor.
Use the set snmp trap auth command to enable or disable the sending of SNMP traps
upon SNMP authentication failure.
Syntax:
The syntax for this command is:
set snmp trap {enable | disable} auth
Example:
W310-1# set snmp trap enable auth
Authentication trap enabled
Related Commands:
Use the
show snmp
show snmp
User level: user, privileged, supervisor
Use the show snmp command to display SNMP information.
Syntax:
The syntax for this command is:
show snmp
330
command to clear an SNMP trap receiver.
clear snmp trap
command to display SNMP information.
show snmp
command to display SNMP information.
Avaya W310 Command Reference Guide