Snmp Power-On Source Jumper - Magma EB7-X8G2 User Manual

Magma
Each of the LEDs shown above indicates the connectivity status of the PCIe card inserted into the respective PCIe slot.
Once connectivity has been established between the host computer and one (or more) PCIe cards, the respective
LED(s) will light up. The Uplink Port LED will light up as soon as the chassis had linked with the host system regardless of how
many PCIe cards are installed in the chassis, or if none at all. Therefore in normal working conditions it should always be
lit.
The activity LEDs will blink occasionally whenever the host is communicating with the card is a respective slot.

SNMP Power-On Source Jumper

The SNMP module inside the EB7-X8G2-RAS chassis features a power-on source jumper to select between local power-on
(via the master on/off switch) and remote turn-on (via the SNMP software/front end).
In order to gain access to this module (and respective jumper), the top cover of the chassis needs to be removed.
Dismount the chassis from the rack (if applicable) and carefully remove the screws holding the chassis cover in place.
The SNMP module will be located on the right side of the unit oriented with the fans facing us.
EB7-X8G2 | Chapter 6 Troubleshooting 55