Attach Pci Expansion And Power Cable - Magma PCI Expansion System User Manual

FEATURE
To allow them to be as portable as your laptop, the 2 slot expansion
chassis is available with a DC power supply option (Part Number
SUB100WDC). This version ships with an internal DC-DC power
supply and an AC power brick. The DC-DC power supply includes
a male 4-pin XLR connector to provide easy connection to user
supplied DC power source. The AC power brick is provided for
times when AC power is available. In addition, the DC version is
auto-switching. Refer to Appendix B for more information.

Attach PCI Expansion and Power Cable

Carefully position the MAGMA expansion chassis so that the supplied
PCI expansion cable will conveniently reach from the connector of the
CardBus card to the connector on the back of the
chassis.
Attach one end of the PCI expansion cable to the
CardBus card and secure it using the captive
thumbscrews on the cable.
Carefully route the cable to the rear side of the
expansion chassis and attach it to the 68-pin connector, as shown
below:
Secure the cable with the captive thumbscrews. It is important that the
cable be attached securely to the connectors at both ends.
Chapter 2 Hardware Installation
M A G M A
5