Attach Pci Expansion And Power Cable - Magma CB264 User Manual

CAUTION
Remember, if you are using a 220V power source, you will need a
power converter (leave your Voltage Selector Switch at 115V), or a
250V power cord adapter (change your Voltage Selector Switch to
230V), to connect to the power source. Double-check that you have
the correct combination of Voltage Selector Switch setting and
Power Converter or Power Cable Adapter to allow your expansion
chassis to operate safely.
Remember, when traveling, to flip the red Voltage Selector switch, if
necessary.
FEATURE
To allow them to be as portable as your laptop, the 2 slot expansion
chassis is available with a DC power supply option (Part Number
SUB100WDC). This version ships with an internal DC-DC power
supply and an AC power brick. The DC-DC power supply includes
a male 4-pin XLR connector to provide easy connection to user
supplied DC power source. The AC power brick is provided for
times when AC power is available. In addition, the DC version is
auto-switching. Refer to Appendix B for more information.

Attach PCI Expansion and Power Cable

Carefully position the Magma expansion chassis so that the supplied
PCI expansion cable will conveniently reach from the connector of the
Host Card to the connector on the back of the chassis. See your Host
Card Installation Guide for information on installing your Host Card.
Attach one end of the PCI expansion cable to the Host Card and secure
it using the captive thumbscrews on the cable. See the Host Card
Installation Guide for more information on connecting the cable to
the card.
Chapter 2 Hardware Installation
M A G M A
5