Sw1 And Sw2; Install Host Interface Cards - Magma EB7-X8G2 User Manual

Magma

SW1 and SW2

SW1 dipswitch should be set to "ON-EXP" position. SW2 dispswitches should be set to x8, see picture below.
Once the two dispswitches (SW1 and SW2) are set correctly, plug in the Expansion Interface card into the UPSTREAM slot.
This is the designated slot for the Expansion Interface card only. You can not use other PCIe slots, the unit will not work
properly.

Install Host Interface Cards

Install the Host Interface card. Begin the installation of your PCI Express (PCIe) host card by first powering down your
computer. Use the procedures for shutting down your operating system and shutting off power to your system provided
in your owner's manual or system documentation. The PCIe host card is a "half-height," x8-capable PCIe card mounted
to a "full-height" bracket as shown below.
EB7-X8G2 | Chapter 2 Hardware Installation 11