Cleaning The Air Filter - Magma EB7-X8G2 User Manual

Cleaning the Air Filter

The chassis is equipped with an air filter that is easy to remove and clean. To keep your chassis running at its coolest, you
should clean this filter regularly. How often the filter requires cleaning depends on environmental conditions where your
Magma Expansion chassis is located. To clean this filter, follow these simple steps.
First, power down the chassis and then remove the screws on the side of the front panel with a Phillips screwdriver.
NOTE
Note the different types of screws and where they go as you take them out.
Next, open the faceplate slowly and disconnect the wire marked below:
Then remove the foam filter, located behind the faceplate, and clean it with a solution of warm water and mild dish
soap.
Finally, replace the filter, reconnect the LED panel. Secure faceplate with Phillips screws. Tighten screws until snug and
turn on power to the chassis.
EB7-X8G2 | Chapter 5 Chassis Maintenance
Magma
52