Configure Snmp Settings; Temperature Settings - Magma EB7-X8G2 User Manual

Magma
To change the IP address, enter the new static IP address in the IP Address field. Enter the new subnet mask in the
Network Mask field. Enter the IP addresses for the Gateway and the DNS Server in the appropriate fields. Finally, enter a
new network name for the EB7-X8G2-RAS in the DHCP Device Name field for use when accessing the chassis when DHCP
is enabled. If you wish to use DHCP, enter 0.0.0.0 in the IP Address field, but be sure you have the tools and proper
network privileges to access the system after a server had assigned it an IP address.
When you have finished configuring the network settings, you can either configure the SNMP settings as described in the
next section, change the default user name and password, or save the current changes by clicking on the Save Network
Configuration button at the bottom of the screen.
Now you can connect your chassis to the network. To find the IP address assigned by your DHCP server, look in the DHCP
server's list of attached devices for the name you assigned to your EB7-X8G2-RAS chassis.

Configure SNMP Settings

If you are adding your EB7-X8G2-RAS chassis to an existing SNMP network, or if you are planning to trap SNMP errors, you
will need to configure the SNMP settings for use with your SNMP agent.
To configure these values for your SNMP network, select the SNMP section on the top bar and change the default values
to match your requirements.
Change the Read Community Name and Write Community Name fields to match those required by your SNMP network.
The default value is public.
Change the Trap Destination IP Address to the IP address of the computer getting the SNMP data. The default Trap
Destination IP address in the above example was: 192.168.1.2.
Finally, save the newly entered settings:

Temperature settings

EB7-X8G2 | Chapter 4 Install PCIe Cards 37