Power On The Host Computer; Shutting Down - Magma EB7-X8G2 User Manual

Powering ON the expansion unit before the host, allows the higher numbered PCIe buses in the PCIe bus hierarchy to be
at a stable state when the host system issues its master power-on bus reset. Upon powering ON the expansion unit, the
following LEDs on the board are illuminated.
 3.3V, +1.5V , +3.3V Aux, +12v (Green in color)
 Master RST LED (Amber in color)
 Power LED : D1221 ( Green in color)
If the front Power LED indicator and 3.3V, +1.5V , +3.3V Aux, +12v LEDs are not coming ON, please check the power
supply, make sure the switch is set to ON position and the power cord is firmly attached.

Power on the Host Computer

Before powering ON the computer, make sure the Host Interface card is seated correctly in the PCIe slot and the cable
is firmly connected. During the boot up process or while the computer is starting up, the SLOT LED indicators will come
ON and OFF. In this process we have not installed any PCIe cards, all PCIE slots are empty.

Shutting Down

STOP
DO NOT TURN OFF THE MAGMA EXPANSION CHASSIS UNTIL YOU HAVE SHUT DOWN
YOUR COMPUTER COMPLETELY! It can cause a system lockup and data loss.
EB7-X8G2 | Chapter 2 Hardware Installation
Magma
17