Configuring Snmp - Magma EB4-1U User Manual

M A G M A

Configuring SNMP

To ensure that you can
successfully monitor your
new system, you will
need to connect it to a
local or private hub using
a standard RJ45
Ethernet Cable. Connect
one end of the cable to
the RJ45 port, located on
the rear of the chassis,
and the other end to your local hub. Then connect a local computer to
this hub as well. An alternative way is to use a crossover cable
connected to the EB4-1U on one end and your computer on the other.
Go to Start->Control Panel->Network Connections and set your IP
address of your local machine to 10.203.0.10 and your gateway to
10.203.0.1, click OK.
Open a DOS window on the local computer connected to the hub by
clicking on the Start button and then clicking the Run icon. Make sure
the chassis is powered up. Ping the chassis by typing, ping
10.203.0.186 and press Enter.
Chapter 4 Install Cards and Drives 17