Install Pci Express (Pcie) Cards - Magma EB7-X8G2 User Manual

In order to access the add-in PCIe cards, you will need to remove that bar as follows:
1. Rotate the plastic pieces until their grooves are aligned with the cards.
2. Unscrew the captive screw, lift up and remove the apparatus.
3. Tighten the screw in the black plastic piece to lock it into place and prepare it to lock the PCIe add-in card that will
be installed. Reinsert the bar into the chassis and tighten the captive screw.

Install PCI Express (PCIe) Cards

Electrostatic Discharge (ESD) Warning
All add-in cards are susceptible to electrostatic discharge. When moving cards, it is best to carry the
cards in anti-static packaging. If you need to set a circuit card down, be sure to place it inside or on
top of an anti-static surface. For more information, see
the Preface.
WARNING
High voltages are present inside the expansion chassis when the unit's power cord is
plugged into an electrical outlet. Disconnect the power cord from the AC outlet before
removing the enclosure cover. Turning the system power off at the power on/off switch
does not remove power to components. High voltage is still present.
"Protecting Against Electrostatic
EB7-X8G2 | Chapter 4 Install PCIe Cards
Magma
Discharge" in
32