Installation Of Low Profile Bracket - Magma EB7-X8G2 User Manual

For low profile case applications, you may need to change the mounting bracket to the low profile bracket that shipped
with your system. This is done by removing the screws that hold the card to the bracket. Be sure you are using proper ESD
procedures when completing this action.

Installation of low profile bracket

Detach the standard bracket from the card, and place the low profile bracket and secure it.
Before installing the Host Interface card into PCIe slot, check the DIP switch settings.
 Check the red Dipswitch (SW1) on the Host interface card, make sure it is set to OFF= HOST.
 Check the SW2 Dipswitch, both toggle switches should be set to OFF position (x8).
Once the dipswitches are set correctly and the host computer is off and all power cords are disconnected from the AC
outlet, insert the PCI Express host card into a vacant x8 (or x16) PCIe slot by gently pushing the card until it is firmly
seated. Then secure the card to the slot with a mounting screw.
EB7-X8G2 | Chapter 2 Hardware Installation
Magma
12