Add Screws To Rack Post; Attach Slide Rail To Rack; Attach Chassis To Slide Rail - Magma EB7-X8G2 User Manual

Add Screws to Rack Post

Attach 2 Panhead screws into the rack post where you want the chassis
mounted. Be sure you have measured accurately to ensure that everything fits in
the rack correctly. Leave the screws untightened until after you place the slide
rail's fingers between the screws as shown.
If your rack has holes too large for the screws, you can use the Bar Nut to secure
your mounting by inserting the Panhead screw through the rack hole and
screwing it into the Bar Nut on the reverse side of the rack post, as shown.
NOTE
Notice that the holes on the Bar Nut are spaced unevenly to accommodate
different racks.

Attach Slide Rail to Rack

Attach to inside of rack with "fingers" pointing "out" and the end bracket
to the rear. Secure each Slide Mount with 4 screws as shown below.
Secure the slide rail to the rack with 2 screws to both front and rear posts.
After you have secured the slide rail fingers to the rack posts, tighten the 2
screws used to attach the slide rail to the end bracket.

Attach Chassis to Slide Rail

The chassis mounts into the rack from the front. Insert the chassis into the rack slide and press it forward until the chassis
stops. When the chassis is completely inserted into the rack, secure the mounting brackets 2 screws on each side.
EB7-X8G2 | Chapter 6 Troubleshooting
Magma
63