Nv Media Card Operation - Emerson Unidrive M200-01100017 Quick Start Manual

8

NV Media Card Operation

Figure 8-1 Installing the AI-Backup adaptor (SD Card)
1. Identify the two plastic fingers on the underside of the AI-Backup adaptor (1) - then insert the two
fingers into the corresponding slots in the spring-loaded sliding cover on the top of the drive.
2. Hold the adaptor firmly and push the spring loaded protective cover towards the back of the drive
to expose the connector block (2) below.
Press the adaptor downwards (3) until the adaptor connector locates into the drive connection below.
Figure 8-2 Basic NV Media Card operation
Drive reads all
parameters from
the NV Media Card
Pr 00.030
Drive automatically
writes to the
Media Card
when a parameter
save is performed
Pr 00.030
The whole card may be protected from writing or erasing by setting the read-only flag, refer to the
Drive User Guide for further information. The card should not be removed during data transfer, as the
drive will produce a trip. If this occurs then either the transfer should be reattempted or in the case of
a card to drive transfer, default parameters should be loaded.
Unidrive M200-201 Quick Start Guide
Issue Number: 5
1
1 1
2 2
= rEAd +
= Auto +
2
3
1
Pr 00.030 = Prog +
Pr 00.030 = boot +
Programs all drive
parameters to the
NV Media Card
2
NOTE
Overwrites any
data already in
data block 1
Drive boots from the
NV Media Card on
power up and
automatically writes
to the Media Card
when a parameter
save is performed
33