Emerson unidrive m200 User Manual page 169

Safety Product Mechanical
information information installation
Table 11-14 Acoustic noise data
Max speed
Size
1
2
3
4
5
6
11.1.18 Overall dimensions
H Height including surface mounting brackets
W Width
D Projection forward of panel when surface mounted
F Projection forward of panel when through-panel mounted.
R Projection rear of panel when through-panel mounted.
Table 11-15 Overall drive dimensions
Size
H W
160 mm
1
(6.3 in)
75 mm
(2.95 in)
205 mm
2
(8.07 in)
226 mm 90 mm
3
(8.9 in) (3.54 in)
277 mm 115 mm
4
(10.9 in) (4.5 in)
391 mm 143 mm
5
(15.39 in) (5.63 in)
391 mm 210 mm
6
(15.39 in) (8.27 in)
11.1.19 Weights
Table 11-16 Overall drive weights
Size Model
1
2
3
All
4
5
6
11.1.20 Input current, fuse and cable size ratings
The input current is affected by the supply voltage and impedance.
Typical input current
The values of typical input current are given to aid calculations for power
flow and power loss.
The values of typical input current are stated for a balanced supply.
Maximum continuous input current
The values of maximum continuous input current are given to aid the
selection of cables and fuses. These values are stated for the worst case
condition with the unusual combination of stiff supply with bad balance.
The value stated for the maximum continuous input current would only
be seen in one of the input phases. The current in the other two phases
would be significantly lower.
The values of maximum input current are stated for a supply with a 2 %
negative phase-sequence imbalance and rated at the maximum supply
fault current given in Table 11-17.
Unidrive M200 / M201 User Guide
Issue Number: 4
Electrical Getting Basic
installation started parameters
Min speed
dBA dBA
46.7
45
58.6 49
60.8
57
57 40
Dimension
D F R
130 mm
(5.1 in)
150 mm
(5.9 in)
160 mm
(6.3 in)
175 mm
(6.9 in)
192 mm
(7.60 in)
221 mm
(8.70 in)
kg lb
0.75 1.65
1.0 2.2
1.5 3.3
3.13 6.9
7.4 16.3
14 30.9
Running the NV Media
Optimization
motor Card
Table 11-17 Supply fault current used to calculate maximum input
currents
Model
All
Advanced
Technical data Diagnostics
parameters
Symmetrical fault level (kA)
100
UL Listing
169