Safety
Product
Mechanical
information
information
installation
Figure 3-13 Installing the AI-485 adaptor to the drive
•
Identify the two plastic fingers on the underside of the AI-485 Adaptor (1) - then insert the two fingers into the corresponding slots in the spring-
loaded sliding cover on the top of the drive.
•
Hold the adaptor firmly and push the spring loaded protective cover towards the back of the drive to expose the connector block (2) below.
•
Press the adaptor downwards (3) until the adaptor connector locates into the drive connection below.
Figure 3-14 Removal of the AI-485 adaptor
•
To remove the AI-Adaptor, pull it up away from the drive in the direction shown (1)
26
Electrical
Getting
Basic
installation
started
parameters
1
Running the
NV Media
Optimization
motor
Card
2
3
Advanced
Technical data Diagnostics
parameters
Unidrive M200 / M201 User Guide
Issue Number: 4
UL Listing