Emerson unidrive m200 User Manual page 73

Safety Product Mechanical
information information installation
Figure 5-3 Display modes
Timeout
240 s or hold
Go to Status if no
option installed
Press and
release to
discard new
value and return
to original value
Holding
or timeout will discard
new value and return
to original value.
NOTE
The up and down buttons can only be used to move between menus if Pr 00.010 has been set to show 'ALL'. Refer to section 5.9 Parameter access
level and security on page 76.
Unidrive M200 / M201 User Guide
Issue Number: 4
Electrical Getting Basic Running the
installation started parameters
If Drive Status (Pr 10.101) = 4 (Run)
Show value only
If Drive Status (Pr 10.101) <> 4
Show status only
Press and release to
go back to status
Slot select
(Only if option installed)
Press
Edited digit flashes
Press and release to
edit Slot
Menu select
Press
Edited digits flash
Press and release to
edit Menu
Parameter select
Press or
Edited digits flash
Press and release to
edit Parameter
- Press and release to accept
new value to be set.
- Reset drive if required.
- Execute action if required.
Edit
Press or to select value
- Edited digit flashes
- Holding or increases or decreases value.
- Modified value has a direct effect on the drive
except routing parameters and special parameters.
- New value can be validated or discarded.
- Holding + or
digit.
NV Media
Optimization
motor Card
Status
or
Press and release.
Show last slot / menu / param
selected
or
or
or to select _ or 1
Press and release to
edit Menu
or to select menu
Press and release to
edit Parameter
to select parameter.
Press and
release to view
View
Press and release
to edit
edit the next or previous
Advanced
Technical data Diagnostics
parameters
Parameter format s.mm.ppp
s: _ or 0: for drive. If drive is
selected then hide first digit and
show only menu and parameter.
1: for option
mm: menu number (0 to 99)
ppp: parameter number (0 to 999)
Show previous or next
parameter
or
- Press and release to go to next or
previous parameter. Parameter flashes
briefly then goes back to View.
- Holding or scrolls through each
parameter within the menu.
- Holding and together sets value to
zero.
UL Listing
73