Dimensions And Mounting Methods - Emerson unidrive m200 User Manual

Safety Product Mechanical
information information installation
3.5

Dimensions and mounting methods

The drive can be either surface or through-panel mounted using the appropriate brackets. The following drawings show the dimensions of the drive
and mounting holes for each method to allow a back plate to be prepared.
The Through-panel mounting kit is not supplied with the drive and can be purchased separately, below are the relevant part numbers:
Table 3-1 Through-panel mounting kit part numbers for size 5 to 6
Size
5
6
If the drive has been used at high load levels for a period of time, the heatsink can reach temperatures in excess of 70 °C (158 °F). Human
contact with the heatsink should be prevented.
WARNING
Many of the drives in this product range weigh in excess of 15 kg (33 lb). Use appropriate safeguards when lifting these models.
A full list of drive weights can be found in section 11.1.19 Weights on page 169.
WARNING
3.5.1 Surface mounting
Figure 3-17 Surface mounting the size 1 drive
75 mm (3.0 in)
28
Electrical Getting Basic
installation started parameters
CT part number
3470-0067
3470-0055
130 mm (5.12 in)
Running the NV Media
Optimization
motor Card
Advanced
Technical data Diagnostics
parameters
11 mm
(0.43 in)
53 mm (2.1 in)
143 mm
(5.63 in)
Unidrive M200 / M201 User Guide
Issue Number: 4
UL Listing
Æ5.0 mm
(0.2 in) x 4 holes