Emerson unidrive m200 User Manual page 6

Control Techniques Ltd
The Gro
Newtown
Powys
UK
SY16 3BE
This declaration applies to Unidrive M variable speed drive products,
comprising models numbers as shown below:
Maaa-bbcddddd Valid characters:
aaa 100, 101, 200, 201, 300, 400
bb 01, 02, 03
c 1,2 or 4
00013, 00017, 00018, 00023, 00024, 00032,
00033,
ddddd
00041, 00042, 00056, 00075
00056, 00073, 00094, 00100
The AC variable speed drive products listed above have been designed
and manufactured in accordance with the following European
harmonized standards:
Adjustable speed electrical power drive
EN 61800-5-1:2007 systems - safety requirements - electrical,
thermal and energy
Adjustable speed electrical power drive
EN 61800-3:2004 systems. EMC product standard including
specific test methods
Electromagnetic compatibility (EMC). Generic
EN 61000-6-2:2005 standards. Immunity standard for industrial
environments
Electromagnetic compatibility (EMC). Generic
EN 61000-6-4:2007 standards. Emission standard for industrial
environments
Electromagnetic compatibility (EMC), Limits,
EN 61000-3-2:2006 Limits for harmonic current emissions
(equipment input current <16 A per phase)
Electromagnetic compatibility (EMC), Limits,
Limitation of voltage fluctuations and flicker in
EN 61000-3-3:2008
low-voltage supply systems for equipment
with rated current <16 A
EN 61000-3-2:2006 Applicable where input current <16 A. No limits
apply for professional equipment where input power >1 kW.
6
Declaration of Conformity
Moteurs Leroy-Somer
Usine des Agriers
Boulevard Marcellin Leroy
CS10015
16915 Angoulême Cedex 9
France
These products comply with the Low Voltage Directive 2006/95/EC and
the Electromagnetic Compatibility Directive 2004/108/EC.
T. Alexander
Vice President, Technology
Newtown
Date: 18th December 2013
These electronic drive products are intended to be used with
appropriate motors, controllers, electrical protection components
and other equipment to form complete end products or systems.
Compliance with safety and EMC regulations depends upon
installing and configuring drives correctly, including using the
specified input filters. The drives must be installed only by
professional assemblers who are familiar with requirements for
safety and EMC. The assembler is responsible for ensuring that the
end product or system complies with all the relevant laws in the
country where it is to be used. Refer to the User Guide. An EMC
Data Sheet is also available giving detailed EMC information.
Unidrive M200 / M201 User Guide
Issue Number: 4