Hitachi AMS 2000 Reference Manual page 48

Table 1-8: Pairmon Command Parameters (Continued)
Parameter
Options
(continued)
•
NOTE:
TCE pair.
# pairmon -allsnd
Group Pair vol
oradb oradb1
oradb oradb2
The output of the pairmon command includes:
• Group: Shows the group name (dev_group) described in the
configuration definition file.
• Pair vol: Shows the paired volume name (dev_name) in the specified
group which is described in the configuration definition file.
• Port targ# lun#: Shows the port ID, TID, and LUN described in the
configuration definition file.
• LDEV#: Shows the array LDEV ID for the specified device. LDEV
indicates LU.
• Oldstat: Shows the old pair status when the status of the volume is
changed.
• Newstat: Shows the new pair status when the status of the volume is
changed.
• Code: Shows the array-internal code for the specified status.
1–30
Hitachi AMS 2000 Family Command Control Interface (CCI) Reference Guide
-D: Selects the default report mode. In the default mode, if there is pair
status transition information to be reported, one event is reported and the
event is reset. If there is no pair status transition information to be reported,
the command waits. The report mode consists of the three flags: -allsnd, -
resevt, and -nowait options.
-allsnd: Reports all events if there is pair status transition information.
-resevt: Reports events if there is pair status transition information, then
resets all events.
-nowait: When this option is specified, the command does not wait when
there is no pair status transition information.
-s <status> ...: Specifies the pair status transition to be reported: smpl,
copy (includes rcpy), pair, psus, psue. If two or more statuses are specified
following -s, masking is done according to the logical OR of the specified
statuses. If this option is not specified, pairmon displays all events which
received information from HORCM.
In TrueCopy/TCE operation, do not specify the MU# to TrueCopy/
-nowait
Port targ# lun#
CL1-A 1 5
CL1-A 1 6
Figure 1-24: Pairmon Command
Performing CCI Operations
Value
LDEV#... Oldstat code –> Newstat code
5... SMPL 0x00 –> COPY
6... PAIR 0x02 –> PSUS
0x01
0x04