Sync And Syncd Subcommand - Hitachi AMS 2000 Reference Manual

• LUN: Shows the LU number of each hard disk on the specified device
adapter port or bus. This item shows LDEV# of the partner who
becomes a pair in or among the array.
Sync and syncd subcommands
The sync (synchronization) subcommand sends unwritten data remaining
on the Windows 2000 or Windows Server to the specified devices. The
syncd (synchronization delay) subcommand waits for delayed I/O to
complete before synchronizing.
syncd subcommand parameters.
•
Table 1-30: Sync and Syncd Subcommand Parameters
Parameter
Command Name
Format
Argument
1–76
Hitachi AMS 2000 Family Command Control Interface (CCI) Reference Guide
Table 1-30
sync
syncd
-x sync[d] A: B: C: ...
-x sync[d] all
-x sync[d] drive#(0-N) ...
-x sync[d] Volume#(0-N) ...
-x sync[d] D:\directory or \directory pattern ... (Windows 2000/Windows
Server systems only)
A: B: C:[\directory or \directory pattern] ... : Specifies the logical
devices that you want to synchronize. The data is flushed to the specified
logical device and to the physical device that corresponds to the specified
logical device.
If a directory-mounted volume exists in the specified logical device, the
data will be flushed including the directory-mounted volume as follows:
pairsplit –x sync D:
[SYNC] D: HarddiskVolume2
[SYNC] D: \hd1 HarddiskVolume8
[SYNC] D: \hd2 HarddiskVolume9

[\directory or \directory pattern] (Windows 2000, Windows
Server systems only)
Specifies the directory or the directory pattern for searching the directory
mount point in the logical device.
If directory is specified: The applicable directory-mounted volume will
be flushed.
pairsplit –x sync D:\hd1
[SYNC] D:\hd1 HarddiskVolume8
If directory patter is specified: The directory-mounted volume that
matches the specified pattern will be flushed.
pairsplit –x sync D:\h
[SYNC] D:\hd1 HarddiskVolume8
[SYNC] D:\hd2 HarddiskVolume9
Performing CCI Operations
lists and describes the sync and
Value