Hitachi AMS 2000 Reference Manual page 192

Sense Detailed
code code
9609 x037
9609 x038
9609 x039
9609 x03A
9609 x03E
9609 x041
9609 x042
9609 x058
9609 x086
9609 x087
9609 x088
9609 x089
3–36
Hitachi AMS 2000 Family Command Control Interface (CCI) Reference Guide
Table 3-5: Sense Codes (Continued)
Sub
Error contents
code
94 The remote array is busy.
Or the copy operation cannot be
performed because the capacity of
the DP pool is depleted or can be
depleted by this copy for either the
S-VOL or an S-VOL of
ShadowImage cascading in the
remote array.
Or the status of the object LU is
ather than normal or regression.
Or the full capacity mode is not
supported.
94 Both of the two paths of the
remote array were detached.
94 The process is in progress.
94 The process is in progress.
94 The S-VOL command is receiving a
command.
94 The S-VOL of the remote array is
doing a duplicate writing.
94 The capacity is beyond the limits
of supported.
94 The ShadowImage P-VOL of the
remote array is in the PSUE (S-
VOL Switch) status.
94 The S-VOL of the remote array is
specified as a command device.
94 The S-VOL of the remote array is
executing format.

Or management information of
Dynamic Provisioning for the LU
specified as S-VOL in the remote
array is being updated.
94 The S-VOL of the remote array is
specified as the DM-LU.
94 The S-VOL of the remote array is
in the status of S-VOL Disable.
Maintenance log and tracing functions
Recommended Action
Retry after checking the pair
status of the LU, Array ID,
number of the connected
arrays, and group number.
Or resolve the insufficient
capacity of the DP pool and
retry.
Or make the status of the
object LU normal or
regression. Or check the
firmware version of array.
Check the status of the path.
Retry after waiting for a
while.
Retry after waiting for a
while.
Retry after waiting for a
while.
Retry after waiting for a
while.
Delete unnecessary pairs of
the remote array.
Contact the service
personnel.
Specify a volume other than
a command device of the
remote array as the S-VOL.
Create the pair again after
the quick formatting is
completed.
Or retry after waiting a while.
Specify a volume other than
the DM-LU of the remote
array as the S-VOL.
Check the status of the
remote array and cancel the
access attribute.