Hitachi AMS 2000 Reference Manual page 187

Sense Detailed
code code
9608 008E
9608 008F
9608 00A6
9608 00A7
9608 00A8
9608 00A9
9608 00AA
9608 00AB
9608 00AC
9608 00AD
9608 OOAE
9608 00AF
9608 OOB0
9608 00B1
Hitachi AMS 2000 Family Command Control Interface (CCI) Reference Guide
Table 3-5: Sense Codes (Continued)
Sub
Error contents
code
84 LU capacities of the P-VOL and V-
VOL are different.
84 When creating a pair specifying a
group ID, the specified group ID is
already used for a ShadowImage
pair.
84 The operation cannot be
performed due to insufficient
capacity of the DP pool for the
specified P-VOL.
84 The operation cannot be
performed due to insufficient
capacity of the DP pool for the LUs
which belong to data pool.
84 Management information of
Dynamic Provisioning is being
updated.
84 The operation cannot be
performed due to insufficient
capacity of the DP pool for the P-
VOL of a pair in the same group.
84 The operation cannot be
performed due to insufficient
capacity of the DP pool for the LU
specified for data pool of a pair in
the same group.
84 The V-VOL of the specified pair is
the P-VOL of a TrueCopy or TCE.
84 Access attribute has been set to
the V-VOL of the specified
SnapShot pair.
84 The memory reconfiguration
process is in progress.
84 The memory reconfiguration
process is in progress.
84 The full capacity mode differs
between the P-VOL and data
pools.
84 The full capacity mode differs
between the P-VOL and data
pools.
84 The status of the ShadowImage
pair cascading with the specified
SnapShot pair is invalid.
Maintenance log and tracing functions
Recommended Action
Check the capacity of the LU.
Check the specified group ID.
Check the capacity of the DP
pool.
Check the capacity of the DP
pool.
Retry after waiting for a
while.
Check the capacity of the DP
pool.
Check the capacity of the DP
pool.
Retry after deleting the
TrueCopy or TCE pair.
Change the attribute to
Read/Write and reset S-VOL
Disable. If mode is set, reset
it using CCI. Then, delete the
pair.
Retry after the memory
reconfiguration process
completes.
Retry after the memory
reconfiguration process
completes.
Set both P-VOL and data
pools the same value.
Set both P-VOL and data
pools the same value.
Check the status of the
ShadowImage pair.
3–31