Hitachi AMS 2000 Reference Manual page 186

Sense Detailed
code code
9608 007E
9608 007F
9608 0080
9608 0081
9608 0082
9608 0083
9608 0084
9608 0085
9608 0086
9608 0087
9608 0088
9608 0089
9608 008A
9608 008B
9608 008C
9608 008D
3–30
Hitachi AMS 2000 Family Command Control Interface (CCI) Reference Guide
Table 3-5: Sense Codes (Continued)
Sub
Error contents
code
84 An instruction to create a pair was
issued to a 
P-VOL, which has one or more
pairs, specifying a pool ID
different from that has been
assigned.
84 The RAID group, to which the
specified P-VOL belongs, is RAID
0.
84 The V-VOL has already created the
maximum number of pairs for the
specified P-VOL.
84 The specified P-VOL is a SubLU of
a unified LU.
84 The specified P-VOL is a Volume
Migration pair.
84 The specified P-VOL is a
ShadowImage pair.
84 The specified P-VOL has been
defined to the command device.
84 The capacity of SnapShot pair is
beyond the limits.
84 The process is in progress.
84 It is exceeded the total allowable
maximum number of TCE and
SnapShot pairs.
84 The specified P-VOL is a MainLU of
a unified LU, which includes an LU
with a capacity smaller than 1 GB.
84 The specified P-VOL has been set
to the current Cache Residency
LU.
84 The specified P-VOL has been set
to the reserved Cache Residency
LU.
84 The specified P-VOL is the LU, for
which a change of the cache
partitions had been reserved to
other directory.
84 Differential bit map is insufficient. Delete the unnecessary
84 When the specified P-VOL is a TCE
pair, the specified pool ID and the
used pool ID are not the same.
Maintenance log and tracing functions
Recommended Action
Check the specified pool ID.
Check the RAID level of the
specified LU.
Check the number of V-VOLs
which have paired with the P-
VOL.
Check the status of the LU.
Check the attribute of the LU.
Check the attribute of the LU.
Check the attribute of the LU.
Confirm the capacity of all
SnapShot P-VOLs, all P-VOLs
and S-VOLs of TCE pairs, and
data pools less than or equal
to the supported capacity for
the installed cache memory.
Retry after waiting for a
while.
Delete the unnecessary
pairs.
Check the status of the LU.
Check the status of the LU.
Check the status of the LU.
Check the status of the LU.
pairs.
Check the specified pool ID.