Hitachi AMS 2000 Reference Manual page 174

Sense Detailed
code code
9576 x02B
9576 x030
9576 x031
9576 x032
9576 x035
9576 x038
9576 x03D
9576 x03F
9576 x040
9576 x041
9576 x045
9576 x046
9576 x047
9576 x048
9576 x049
3–18
Hitachi AMS 2000 Family Command Control Interface (CCI) Reference Guide
Table 3-5: Sense Codes (Continued)
Sub
Error contents
code
94 Both of the two paths of the
remote array were detached.
94 The S-VOL is undefined.
94 The WWN of the remote array is
illegal.
94 The remote array is receiving a
command.
94 The optional feature of TrueCopy
or TCE of the remote array is
invalid.
94 Both of the two paths of the
remote array were detached.
94 Pair status of corresponding LU
does not match.
94 The LU assigned to a TrueCopy
pair has already been paired by
ShadowImage.
94 The object LU of the remote array
is being paired as a volume of
ShadowImage whose status is
RCPY or cannot accept Read/Write
instructions.
94 The process is in progress.
94 The stripe size of the object LU of
the remote array is other than 64
kB.
94 The object LU of the remote array
is being restored as a volume of
SnapShot or cannot accept Read/
Write instructions.
94 The specified LU is an S-VOL of
ShadowImage.
94 The specified LU is an S-VOL of
ShadowImage.
94 The object LU of the remote array
is being quick formatted.
Management information of
Dynamic Provisioning for the LU
specified as S-VOL in the remote
array is being updated.
Maintenance log and tracing functions
Recommended Action
Check the status of the path.
Check the attribute of the LU.
Check the remote array
WWN.
Retry after waiting for a
while.
Unlock and validate the
optional feature.
Check the status of the path.
Confirm the pair status of LU
and the other side's LUN.
Check the pair status of the
LU.
Check the pair status of the
LU.
Retry after waiting for a
while.
Make the stripe size of the LU
of the remote array 64 kB.
Place the SnapShot pair,
which comprises the LU of
the remote array, in the SMPL
status once and then operate
the pair.
Specify an LU other than a
ShadowImage S-VOL that
comprises the LU of the
remote array (at the time of a
swap).
Split the ShadowImage pair
that comprises an LU of the
remote array.
Create the pair again after
the quick formatting is
completed.
Retry after waiting a while.