Hitachi AMS 2000 Reference Manual page 218

Sense Detailed
code code
9622 009B
9622 009C
9622 009D
9622 009E
9622 009F
9622 00A0
9622 00A1
9622 00A2
9622 00A3
9622 00A4
9622 00A5
9622 00A6
9622 00A7
3–62
Hitachi AMS 2000 Family Command Control Interface (CCI) Reference Guide
Table 3-5: Sense Codes (Continued)
Sub
Error contents
code
84 There is one or more TCE S-VOLs,
which is cascaded with a SnapShot
P-VOL being restored, in the target
CTG.
84 There is one or more TCE S-VOLs,
which is cascaded with a SnapShot
P-VOL that was placed in the PSUE
status during restoration, in the
target CTG.
84 There is one or more S-VOLs of
TCE pair in the same CTG, the
RAID group that belong to is in
Power Saving mode.
84 The firmware internal error
occurred.
84 The specified secondary sequence
number does not match with the
remote array serial number.
84 The command cannot execute
because the Auto Migration is
undergoing.
84 The command cannot execute
because the Auto Migration is
undergoing.
84 The command cannot execute
because the Auto Migration is
undergoing.
84 The RAID group to which the
specified LU belongs indicates a
status other than Normal.
84 An LU that belongs to the RAID
group that indicates a status other
than Normal is included in the data
pool that is specified in the pair
operation, or is used by specified
pair.
84 An LU that belongs to the RAID
group that indicates a status other
than Normal is included in the
group to which the specified pair
belongs.
84 An LU, belonging to the RAID
group that indicates a status other
than Normal, is included in the
data pool that is used by pairs
belonging to the same group as
the specified pair.
84 The LU created in DP pool was
specified as P-VOL.
Maintenance log and tracing functions
Recommended Action
Check the status of each LU
in the target CTG.
Check the status of each LU
in the target CTG.
Check the status of each LU
in the target CTG.
Retry after waiting for a
while. If an error occurred
again, contact the service
personnel.
Check the specified
command device number.
Check the Migration status.
Check the Migration status.
Check the Migration status.
Retry after the status
becomes Normal.
Retry after the RAID group
status becomes Normal.
Retry after the RAID group
status becomes Normal.
Retry after the RAID group
status becomes Normal.
Specify an LU other than the
LU created in DP pool.