Hitachi AMS 2000 Reference Manual page 196

Sense Detailed
code code
9609 x0BD
9609 x0BE
9609 x0C0
9609 x0C1
9609 x0C2
9609 x0C5
9609 x0D9
9609 x0E0
9609 x0E5
9609 x0EA
9609 x0EA
3–40
Hitachi AMS 2000 Family Command Control Interface (CCI) Reference Guide
Table 3-5: Sense Codes (Continued)
Sub
Error contents
code
94 The S-VOL in the remote array
cannot change an ownership of LU
and a time-out occurred.
94 The S-VOL in the remote array
cannot change an ownership of LU
and, at the same time, the CTG#
is illegal.
94 The S-VOL in the remote array
does not exist on the default
owner controller and, at the same
time, its disk drives are being spun
up.
94 The S-VOL in the remote array
does not exist on the default
owner controller and, at the same
time, it is making the system copy.
94 The S-VOL in the remote array
does not exist on the default
owner controller and, at the same
time, it is writing the takeover
information.
94 The cycle time that has been set
for the remote array is less than
the minimum interval.
94 The status of the remote array is in
an inappropriate condition to
operate the TrueCopy pair.
94 Auto Migration is being executed
in the remote array just now.
94 The RAID group, in which the LU
belongs that will be specified to
the S-VOL of the remote array,
indicates a status other than
Normal.
94 The LU created in DP pool was
specified as S-VOL.
94 Management information of
Dynamic Provisioning for the LU
specified as S-VOL in the remote
array is being updated.
Maintenance log and tracing functions
Recommended Action
Check the status of the
remote array and retry after
waiting for a while.
Check the status of the
remote array.
Check the status of the
remote array and retry after
waiting for a while.
Check the status of the
remote array and retry after
waiting for a while.
Check the status of the
remote array and retry after
waiting for a while.
Check the cycle time that has
been set for the remote
array.
Check the Array ID, pair
status of local and remote
replication, status of the
RAID group to which the
target LU belongs, and
reconfigure memory status.
Retry after waiting the RAID
group status becomes
Normal in case that the RAID
group indicate a status other
than Normal. Retry after the
process of reconfigure
memory is completed if it is
in progress.
Execute again after the
Migration is completed.
Retry when the status
becomes Normal.
Specify an LU other than the
LU created in DP pool.
Retry after waiting a while.