Emergency Recovery From Power Failure - Thermo Scientific RC 6 Plus Operation Instructions Manual

Emergency
Recovery from
Power Failure
Thermo Fisher Scientific
When the displayed ω
Note
decelerates and stops. During deceleration,ω
displayed until a stop.
2
w T is selectable between 0.01E03 and 9.99E17.
2
The w T operation is canceled by changing the set time or changing the
operation mode to the programmed operation mode. When the FUNCTION
2
indicator shows the w
2
indicated on the w T SET column by changing the set time.
2
The w T indicator shows the current w
When performing the RTC operation and the ω
Note
combination, following phenomenon may occur due to a conversion error from
the set ω T to the run time. (There is no error in operation for the set ω
2
Table 4-11.
Conversion Error in RTCOoperation
RTC Setting
When setting the operation start
time
When setting the operation end time
WARNING
When servicing the centrifuge, be sure to turn off the POWER switch, turn off
the distribution board of your centrifuge room, and then wait for at least three
minutes before removing covers or tables from the centrifuge to avoid electrical
shock hazards.

Emergency Recovery from Power Failure

2 Treaches the set value of ω
2
2
T mode, the w T mode is canceled and no value is
2
T value computed during operation.
Phenomenon
Actual operation does not start at
the displayed time exactly.
Actual operation does not end at the
displayed time exactly.
OPERATION
2
T, the machine
T is integrated and its result is
2
T operation in
2
RC-6 PLUS
T.)
4-23