Step-Mode Operation - Thermo Scientific RC 6 Plus Operation Instructions Manual

OPERATION

Step-mode Operation

Step-mode
Operation
4-14 RC-6 PLUS
Table 4-7.
Recalled Run Conditions
Step Key operation
1 Move the cursor to
PROG and press
the ENTER key.
2 Press the ENTER
key when the
cursor stays on
CALL.
3
Enter the desired
MEMORY No. with
the ten-key
numerical pad and
press the ENTER
key. (e.g.: recalling
run conditions
saved at
)
MEMORY No. 2
4 Mount the rotor
and press the
START key.
This centrifuge has the step-mode operation capability that allows you to save
three different sets of values for a run parameter set in a single memory location
(MEMORY Nos. 31 - 33, 41 - 43, and 51 - 53) and then change some or all of
Screen display and notices
The FUNCTION field turns to the PROGRAM
field.
The screen turns to the MEMORY No. LIST
screen.
The recalled run conditions are displayed.
The MEMORY No. appears on the message display.
Only the saved MEMORY No. can be recalled
* The rotor starts rotating.
* When reentering (changing) a run condition of the
recalled MEMORY No. (e.g., SPEED), the MEMORY
No. is canceled.
Recall the MEMORY No. again if necessary.
* The MEMORY No. cannot be changed (or recalled)
while the rotor is rotating.
.
Thermo Fisher Scientific