Thermo Scientific RC 6 Plus Operation Instructions Manual page 32

OPERATION
Basic Operation
Cursor Keys
Designating the Rotor
4-4 RC-6 PLUS
A cursor appears and blinks on the entry line of a run condition display by
pressing a cursor key as shown in Figure 4-2.
The entry line state varies depending on the presence of cursor as shown
below.
1. Fixed-entry state: No cursor appears in normal state.
2. Ready-to-enter state: By pressing any of the four cursor keys in fixed-entry
state, a cursor appears blinking "0" (or other numeric value) on the entry
line. Desired numeric values can be entered in this state. Press the cursor
keys to move the cursor.
To set desired run conditions, put the RUN SCREEN in the ready-to-enter state.
Move the cursor to the desired item and enter a numeric value. If no numeric
value is entered in ready-to-enter state for 30 seconds or more, the display
automatically turns to fixedentry state.
Note
To enter desired value when the entry line is fixed-entry state (e.g., the
state of RUN SCREEN after turning on the POWER switch), press any of
the four cursor keys to show a blinking cursor and move the cursor to the
desired item with cursor keys. The cursor keys have two functions. One
is to show a cursor on the screen and the other is to move the cursor. The
cursor on the screen can be moved up, down, left and right according to
the arrow marks on the cursor keys.
Figure 4-2.
Entry Line State
Before operation, the rotor used must be designated according to the following
procedure. This centrifuge does not start operation unless a rotor is designated.
This centrifuge performs optimum temperature compensation and maximum
speed checking for the designated rotor.
Thermo Fisher Scientific