Thermo Scientific RC 6 Plus Operation Instructions Manual page 25

Table 3-1.
No Name
1 Field display
Thermo Fisher Scientific
Display Panel Function (refer to Figure 3-1)
Displays the following run conditions.
For SPEED, TIME and TEMP displays, the upper line
shows the actual run state and the lower line shows
the set value. Refer to Setting Run Conditions for
details.
• SPEED (Speed display)
(Upper line)
Displays rotor speed in increments of 10 rpm under
10,000 rpm and increments of 100 rpm over 10,000
rpm.
(Lower line)
Displays rotor speed in increments of 10 rpm under
10,000 rpm and increments of 100 rpm over 10,000
rpm. Set speed range is from 300 rpm to 21,000
rpm.
• TIME (Run time display)
(Upper line)
Displays remaining run time during operation. If
HOLD is selected, displays elapsed run time.
(Lower line)
Run time range is from 1 minute to 99 hours, 59
minutes in increments of 1 minute.
• TEMPERATURE (Temperature display)
(Upper line)Displays
increments of 1 degree centigrade.
(Lower line)Temperature range is from - 20
degrees centigrade to 40 degrees
centigrade in increments of 1 degree centigrade.
• ACCEL (Acceleration rate display)
Displays 1 to 9 acceleration rates.
• DECEL (Deceleration rate display)
Displays 1 to 9 deceleration rates and free coast
(0).
rotor temperature in
CONTROLS, DISPLAYS & INDICATORS
Operation Panel
RC-6 PLUS 3-3