8.3
Changing status monitor function
Changing the display format while power is on
The item displayed in the standard monitor mode (*1 on the left side of table on page H-2), for example, operation
frequency which is displayed by default in this way: "=" when power is on or "" when power is off, can be
changed to any item shown on page H-7. This new format, however, will not display an assigned prefix such as
or .
・ Standard monitor mode Standard monitor display selection ()
Title
If is set to , the monitored values selected with (standard monitor display selection parameter) are
displayed one after another.
If is set to or , the monitored values indicate the maximum or minimum values in each operation mode.
When the inverter not running, the monitored values indicate the last hold value.
The peak hold and minimum hold values are not reset by the motor is in operation or in standstill. The monitor is
displayed values after turned on the power or after the reset with the EASY key.
Changing contents of status monitor indication
Regarding contents of status monitor indications appearing in the left column of the table on page H-2, those
marked with *2 to *5 can be changed for others. Select a desirable monitor function from among optional monitor
functions appearing on page H-7.
*2 Frequency command
*3 Output current
*4 Input voltage
8
*5 Output voltage
Title
*If to are set at "" (Output frequency) the operation frequency is not held in trip status.
Function
:Real time
Standard monitor hold
:Peak hold
function
:Minimum hold
~
Standard monitor
Refer to page H-7.
display selection
Function
Status monitor 1 display selection
Status monitor 2 display selection
Status monitor 3 display selection
Status monitor 4 display selection
Adjustment range
Changeable by status monitor 1 display selection ().
Changeable by status monitor 2 display selection ().
Changeable by status monitor 3 display selection ().
Changeable by status monitor 4 display selection ().
Adjustment range
~ Refer to page H-7.
Ditto
Ditto
Ditto
H-6
E6581386
Default setting
Default setting