Simplified Operation Of The Vf-Ps1; Terminal Board Operation - Toshiba TOSVERT VF-PS1 Instruction Manual

3.2

Simplified operation of the VF-PS1

On of three operation modes can be selected: terminal board operation, operation panel and combination of both.
 For other operation modes, refer to Section 5.5.
Terminal board mode
Operation panel mode
Operation panel + terminal board mode

3.2.1 Terminal board operation

In this mode, the motor is started or stopped according to the ON/OFF signal to input terminals (such as the S3
terminal and the F terminal). Also, the frequency is set according to the potentiometer/voltage/current signals to
analog input terminals (such as the RR/S4 terminal, VI/II terminal and RX terminal).
 For more details, refer to Section 7.
 Example of standard connection
MCCB
Power
supply
 Run/Deceleration stop Selecting a command mode for basic parameters = (standard default setting)
are connected: Forward run
and
F CC
are disconnected: Deceleration stop
F
CC
and
(When terminals
PWR
Frequency
F-CC
S3-CC
:Operation by means of external signals
:Operation by pressing keys on the operation panel
sent individually from the operating panel and terminal board.
R/L1
S/L2
T/L3
Inverter
RX VI/II RR/S4 PP
CCA
External potentiometer (or voltage signal RR/S4-CCA:0 to 10Vdc)
and are electrically connected)
P24/PLC
Deceleration
C-3
:Frequency, start/stop signals can be
Motor
U/T1
IM
V/T2
W/T3
F ON:Forward run, OFF:Deceleration stop
R ON:Reverse run, OFF:Deceleration stop
S3
Stand-by:ON:Stand-by, OFF:Coast stop
(The standby signal input
CC
function can be assigned to
P24/PLC the S3 terminal by setting the
parameter  to .)
PWR
Voltage signal:-10~+10Vdc
Voltage signal:0~10Vdc
or current signal:4(0)~20mAdc
 For coast stop
Open the connection between S3 and CC
when stopping the motor in the state
described at left. The monitor on the inverter
at this time will display .
Motor
speed
F-CC
ON
OFF
S3-CC
ON
OFF
E6581386
3
Coast stop
ON
OFF
ON
OFF